Nicet level 1 exam Study guides, Class notes & Summaries

NICET LEVEL 1 IN HIGHWAY CONSTRUCTION 2024 EXAM | ALL 160 EXAM QUESTIONS AND CORRECT ANSWERS | ALREADY GRADED A+

NICET LEVEL 1 IN HIGHWAY CONSTRUCTION ACTUAL EXAM LATEST 2024 QUESTIONS AND CORRECT ANSWERS

NICET LEVEL 1 ACTUAL EXAM LATEST 2024 QUESTIONS AND CORRECT ANSWERS|GRADED A+

NICET LEVEL 1 HIGHWAY CONSTRUCTION EXAM QUESTIONS AND ANSWERS Acceptance - Answer-The written acceptance by the Department of the Work. acceptance testing - Answer-Testing conducted by the Department to measure the degree of compliance to the Contract actual cost - Answer-The computed cost using calculations provided addendum - Answer-A Contract revision or response to a Contractor inquiry issued after advertisement and before the opening of bids. as-built quantity - Answer-The quantity ...

When testing a water level supervisory switch serving a pressure tank a signal shall indicate if the water level _____________from the required level (NFPA 72, Table 14.4.3.2 17 (j) (4) Answer - rises or falls over 3 inches If combination audible/visible appliances are installed the location of the installed appliance shall be determined by the requirements of _______. (Nfpa 72 18.4.8.1) Answer - the visible appliance What is the maximum number of 12 gauge THHN wires that can be inst...

NICET Soils level 1 Exam(Answered)2023

NICET Level 1 inspection and Testing Exam 2024 When using a pulse load tester on a sealed lead acid battery, the minimum acceptable capacity is... -Answer-80% When a software change is made to a fire alarm system, what percentage of the initiating devices not affected by the change must be tested -Answer-10% When testing elevator recall, the elevator should go to the alternate level when: -Answer-The lobby smoke detector on the recall level is activated Minimum requirement for system docu...

NICET Level 1 exam 60 Questions and answers (Practice Electrical Power Testing) The operable part of a manually actuated alarm initiating device shall be not less than inches AFF? - ANS 42

4 wires Answer - what is the maximum number of 14 AWG RHH conductors which can be installed in 1/2 rigid metal conduit? 3.5'-48" to the actuator Answer - Which of the following would be an appropriate mounting height for a pull station? 1 flash per second Answer - What is the minimum flash rate for a visible notification device? 90" to the top of the device Answer - What is the minimum mounting height for audible notification devices? Such that the entire lens is not less then 80...

Whats the maximum coverage area of any fire sprinkler? 225sqft NFPA 14 Standard for the Installation of Standpipe and Hose Systems NFPA 15 Standard for Water Spray Fixed Systems for Fire Protection When was OSHA founded and what does ti stand for? 1971 - the occupational safety and health administration OSHA part 1910? Applies to the general industry OSHA part 1926? Sets forth the safety and health standards under section 107 of the contract work hours an...