The oil storage tank Study guides, Class notes & Summaries

What is a general requirement of the location of the installation of a boiler? - ANSWERSAdequate clearance from combustile construction What temperature must the materials remain under during combustion? - ANSWERS170 degrees What is a requirement for the access of the boiler? - ANSWERSAccess for operation and maintenance must not be hazardous What is required upon installation to operate a boiler? - ANSWERSInspection and test resulting in equipment use permit from commissioner How of...

Combustible Liquid - Correct answer-A liquid with a flash point ABOVE 100F 12.5 - Correct answer-If the current flowing out from an electrical panel is 12.5 amps, and it then flows through an electrical load of 1500 watts, what is the amperage of the remaining current flow of the return circuit? 1000 - Correct answer-If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the wattage? *Power (P) = current (I) x voltage (V) Watts = amps x volts 1987 - Correct answer-The y...

Class A/B Operator for Underground Storage Tank questions and answers The Class A and Class B certification must be renewed every: - 5 years UST financial responsibility requirements apply to what? - 600 gallon used oil tank Secondary Containment is required for what? - New UST Systems, Piping in contact with the ground, and Replacement UST A Class A operator shall maintain the records of UST site inspections for a *minimum* of: - 3 years New owners of an existing UST system shall regist...

Class D license is for anyone driving a vehicle or combined set of vehicles in this weight range _____, as long as they are not carrying hazardous materials - ANSWER-10,001-26,001 pounds A Class D license allows for a driver-for-fire to drive any vehicle fitting into the Class __ requirements - ANSWER-E you must be ____ years old to receive a class D license - ANSWER-17 the maximum width for all vehicles except buses is ___ - ANSWER-8 feet the maximum width for buses is ____ - ANSWER...

The basic methodology of the fire investigation should rely on the use of a ______________________ and attention to all relevant details. a. systematic approach b. approximation approach c. methodology approach d. general approach - ANSWER-a. systematic approach With few exceptions, the proper methodolgy for a fire or explosion investigation is to first _____________________ then investigate the cause, circumstances, conditions, or agencies that brought the ignition source, fuel, and ox...

EPA SECTION 608 CORE (2021-2022 revision) A disposable cylinder should be reduced to what pressure before scrapping? a. 0 psig b. 20 psig c. 50 psig d. 80 psig A major system repair is being performed on a R-22 appliance. What CANNOT be done to recharge the appliance? a. Add R-22 after the repair is complete. b. Retrofit the unit to R-407C. c. Use recovered or recycled R-22 from the same owner. d. Top off the unit with R-410a. A refillable cylinder must not be filled above what ...

P98 Exam Questions With 100% Correct Answers, Latest Updated 2024/2025 (GRADED) Fuel-oil is generally used in buildings in stationary equipment for two purposes - Correct Answer-fuel emergency generators or to fuel equipment used to heat the building. the person supervising the Fuel-Oil Transfer in the Building from one floor to another must hold - Correct Answer-P-98 Certificate of Fitness. Certificate of Fitness holders must maintain all qualifications and comply with all requirements appl...

1.- Where generally Fuel-oil is used in buildings? What purposes? Is used in Stationary Equipment Two purposes: a) Fuel Emergency Generators b) Fuel Equipment used to heat the building 2.- What COF is required to supervise the Fuel-oil transfer in the building from one floor to another? - P-98 and maintain all qualifications and comply w/ requirements applicable to such certificate holder - The P-98 COF is premise-related 3.- The use of the word should refers to: Policies, procedures a...

FDNY COF P-98 Exam With 100% Correct Answers Latest Updated 2024 (Already Graded!!) Where generally *Fuel-oil is used in buildings?* What purposes?* - Correct AnswerIs used in *Stationary Equipments*, Two purposes: a) *Fuel Emergency Generators* b) *Fuel Equipment used to heat the building* 2.- What *COF is required* to supervise the *Fuel-oil transfer in the building from one floor to another?* - Correct Answer-*P-98 and maintain all qualifications and comply w/ requirements applicable to...

What is the first thing a tech should do when arriving at a no combustion call? - Ask how many times the customer reset the unit. What is the best long term solution for preventing a clogged nozzle? - -Remove any underground storage tanks. -Install a quality oil filter. -Cut the suction line 10" above the tank outlet to prevent sludge. Hot water and steam valves are interchangeable. - False When in the presence of a flame, a cad cell normally reads.. - 300-1000 ohms If a pump is used t...